Post by Nelson on Mar 22, 2016 23:31:42 GMT
So, after upgrading my Marlin Firmware to the latest version, I started getting the following error in Repetier Host V 1.6.1:
19:59:38.670 : Error:MAXTEMP triggered, system stopped! Heater_ID: 1
19:59:38.670 : Error:Printer halted. kill() called!
Since I could not figure out what was the problem, I asked for help in the G+ Group. I was lucky enough that Philippe Hervier helped me out very quickly after my initial post. So, it seems like Repetier Host does not like to use the same MAX TEMPS that are located in the firmware's Configuration.h!!! In the firmware, I have the Hotend MAX TEMP at 260 and the Bed MAX TEMP at 110. I had the same temperatures in Repetier Host's Printer Settings (Extruder Tab). This was giving me the errors and not letting the printer connect to Repetier. I changed the as pictured below and no more issues!
Thanks Philippe!
19:59:38.670 : Error:MAXTEMP triggered, system stopped! Heater_ID: 1
19:59:38.670 : Error:Printer halted. kill() called!
Since I could not figure out what was the problem, I asked for help in the G+ Group. I was lucky enough that Philippe Hervier helped me out very quickly after my initial post. So, it seems like Repetier Host does not like to use the same MAX TEMPS that are located in the firmware's Configuration.h!!! In the firmware, I have the Hotend MAX TEMP at 260 and the Bed MAX TEMP at 110. I had the same temperatures in Repetier Host's Printer Settings (Extruder Tab). This was giving me the errors and not letting the printer connect to Repetier. I changed the as pictured below and no more issues!
Thanks Philippe!
